Table of Contents
Advertisement
TX Matrix Hardware Guide
Related
Documentation
Control Plane Connections Between the TX Matrix Router and T640 Router
10
Figure 4: Routing Matrix Control Plane Architecture
TX Matrix Router Description on page 3
TX Matrix System Architecture Description on page 5
Control Plane Connections Between the TX Matrix Router and T640 Router on page 10
The control plane connections between the T640 routers and the TX Matrix router are
provided by UTP Category 5 Ethernet cables between the RJ-45 ports on the TX-CIPs in
the TX Matrix router and the T-CBs in the T640 routers. The maximum length supported
is 100 m. The UTP Category 5 cables do not have to be the same length. The cable wiring
is straight-through (not crossover).
Table 3 on page 11 shows these connections. Each column represents a TX-CIP (
and
), and each cell within a column represents a port on that TX-CIP. Each cell
TX-CIP-1
specifies the TX-CIP port (
CIP
on a T-CB in one of the T640 routers. For example, port
connected to
in chassis
T-CB-0
chassis
, and so on.
LCC1
through
) and its connection to the port labeled
LCC0
LCC3
, port
on
LCC0
LCC1
TX-CIP-0
TX-CIP-0
LCC0
on
TX-CIP-0
is
is connected to
T-CB-0
Copyright © 2010, Juniper Networks, Inc.
in
Advertisement
Table of Contents
Troubleshooting
