Powering Off The Tx Matrix Router - Juniper TX MATRIX Hardware Manual

Related
Documentation

Powering Off the TX Matrix Router

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
NOTE: The Routing Engine boots as the power supply completes its startup
sequence. If the Routing Engine finishes booting and you need to power off
the system, see "Powering Off the TX Matrix Router" on page 131.
Connecting to a Network Device on page 117
Connecting to a Management Console or Auxiliary Device on page 119
Connecting Power to a Two-Input 160-A Power Supply in a TX Matrix Router on page 126
Connecting Power to a Three-Input 240-A Power Supply In 2-INPUT Mode in a TX
Matrix Router on page 128
TX Matrix Preventing Electrostatic Discharge Damage on page 298
To power off the TX Matrix router:
On the external management device connected to the Routing Engine, issue the
1.
request system halt both-routing-engines
shuts down the Routing Engines cleanly, so their state information is preserved. (If
the TX Matrix router contains only one Routing Engine, issue the
command.)
user@host> request system halt both-routing-engines
Wait until a message appears on the console confirming that the operating system
has halted. For more information about the command, see the Junos OS System Basics
and Services Command Reference.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
Switch the circuit breakers on each power supply faceplate to the off position (
3.
TX Matrix Power System Description on page 41
Powering On the TX Matrix Router on page 130
TX Matrix Preventing Electrostatic Discharge Damage on page 298
Chapter 15: Providing Power to the TX Matrix Router
operational mode command. The command
request system halt
).
O
131