Tx Matrix Tx-Sib Leds On The Craft Interface; Tx Matrix Connector Interface Panel (Tx-Cip) Overview; Table 11: Tx-Sib Leds On The Craft Interface - Juniper TX MATRIX Hardware Manual

TX Matrix Hardware Guide
Related
Documentation

TX Matrix TX-SIB LEDs on the Craft Interface

Related
Documentation

TX Matrix Connector Interface Panel (TX-CIP) Overview

38
Table 10: Host Subsystem LEDs (continued)
Label Color
Green
ONLINE
Green
OFFLINE
TX Matrix Host Subsystem Description on page 25
TX Matrix Control Board (TX-CB) LEDs on page 34
TX Matrix RE-600 LEDs on page 28
TX Matrix RE-1600 LEDs on page 30
TX Matrix RE-2000 LEDs on page 32
Each TX-SIB has three LEDs located along the top of the craft interface that indicate its
status. The corresponding TX-SIB slots are identified by the labels on the TX-SIB
online/offline buttons (
SIB0
of the TX-SIB LEDs.

Table 11: TX-SIB LEDs on the Craft Interface

Label Color
Green
ACTIVE
Green
OK
FAIL Red
TX Matrix Switch Interface Boards (TX-SIBs) Description on page 23
TX Matrix TX-SIB LEDs on page 24
TX Matrix Craft Interface Overview on page 34
TX-CIP Description on page 39
Control Plane Ports on page 40
Routing Engine Ports on page 40
Alarm Relay Contacts on page 40
State Description
On steadily Host is online and is functioning normally.
On steadily Host is offline.
through ). Table 11 on page 38 describes the functions
SIB4
State Description
On steadily TX-SIB is passing traffic.
Off TX-SIB is not passing traffic.
On steadily TX-SIB is functioning normally.
Blinking TX-SIB is coming online.
On steadily TX-SIB has failed.
Copyright © 2010, Juniper Networks, Inc.