Copyright © 2018, Juniper Networks, Inc.
slot (
), and the ports labeled
RE0
Routing Engine slot (
RE1
NOTE:
For console devices, configure the serial port to the following values:
Baud rate—9600
Parity—N
Data bits—8
Stop bits—1
Flow control—none
Using a 2.5-mm flat-blade screwdriver, tighten the screws on the connector.
4.
Attach the other end of the cable to the console or auxiliary device.
5.
Figure 63: Console and Auxiliary Serial Port Connector
Chapter 21: Connecting the Router to External Devices
connect to the Routing Engine in the lower
HOST 1
).
179