Connecting The T640 Router To External Devices; Figure 85: Console And Auxiliary Serial Port Connector; Figure 86: Console And Auxiliary Ports On The Cip - Juniper T640 Hardware Manual

Related
Documentation
Copyright © 2013, Juniper Networks, Inc.
NOTE:
For console devices, configure the serial port to the following values:
Baud rate—9600
Parity—N
Data bits—8
Stop bits—1
Flow control—none
Using a 2.5-mm flat-blade screwdriver, tighten the screws on the connector.
4.
Attach the other end of the cable to the console or auxiliary device.
5.

Figure 85: Console and Auxiliary Serial Port Connector

Figure 86: Console and Auxiliary Ports on the CIP

Overview of Connecting the T640 Router to External Devices on page 135
Tools and Parts Required to Connect the T640 Router to External Devices on page 136
T640 DB-9 Connector Pinouts for the Routing Engine AUXILIARY and CONSOLE Ports
on page 450
T640 Routing Engine Interface Cable and Wire Specifications on page 448
Chapter 12: Connecting the T640 Router to External Devices
137