Show Lldp Remote-System - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show lldp remote-system

Displays remote system information for a single port or all ports on a slot.
show lldp [slot/port | slot] remote-system
Syntax Definitions
slot/port
slot
Defaults
By default, a list of all LLDP ports is displayed.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
Use the slot/port or slot parameter to display information for a specific port or for all ports on a specific
module.
Examples
-> show lldp remote-system
Remote LLDP Agents on Local Slot/Port 1/22:
Remote ID 1:
Chassis ID Subtype
Chassis ID
Port ID Subtype
Port ID
Port Description
System Name
System Description
Capabilities Supported
Capabilities Enabled
MED Device Type
MED Capabilities
MED Extension TLVs Present
Remote port MAC/PHY AutoNeg = Supported, Enabled, Capability 0x6c01,
Mau Type=1000BaseTFD - Four-pair Category 5 UTP, full duplex mode
output definitions
Remote LLDP Agents on Local
Slot/Port
Chassis ID Subtype
Chassis ID
Port ID Subtype
page 12-42
Slot number for the module and physical port number on that module
(for example, 3/1 specifies port 1 on slot 3).
The slot number for a specific module.
= 4 (MAC Address),
= 00:d0:95:ea:7c:3a,
= 3 (MAC address),
= 00:d0:95:ea:7c:45,
= (null),
= (null),
= (null),
= Bridge, Router,
= Bridge, Router,
= Network Connectivity,
= Capabilities | Power via MDI-PSE (09),
= Network Policy, Inventory Management,
The Slot number to which the remote system entry is associated and the
physical port number on that module.
The sub type that describes chassis ID.
The chassis ID (MAC address).
The sub type that describes port ID
802.1AB Commands
OmniSwitch CLI Reference Guide June 2012