Primary Authentication (Radius Scheme View) - 3Com S7906E Command Reference Manual

The IP addresses of the primary and secondary accounting servers cannot be the same. Otherwise,
the configuration fails.
The RADIUS service port configured on the device and that of the RADIUS server must be
consistent.
Related commands: key, radius scheme, state.
Examples
# Specify the IP address of the primary accounting server for RADIUS scheme radius1 as 10.110.1.2
and the UDP port of the server as 1813.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] primary accounting 10.110.1.2 1813

primary authentication (RADIUS scheme view)

Syntax
primary authentication ip-address [ port-number ]
undo primary authentication
View
RADIUS scheme view
Default Level
2: System level
Parameters
ip-address: IP address of the primary authentication/authorization server.
port-number: UDP port number of the primary authentication/authorization server, which ranges from 1
to 65535 and defaults to 1812.
Description
Use the primary authentication command to specify the primary RADIUS authentication/authorization
server.
Use the undo primary authentication command to remove the configuration.
By default, no primary RADIUS authentication/authorization server is specified.
Note that:
After creating a RADIUS scheme, you are supposed to configure the IP address and UDP port of
each RADIUS server (primary/secondary authentication/authorization or accounting server).
Ensure that at least one authentication/authorization server and one accounting server are
configured, and that the RADIUS service port settings on the device are consistent with the port
settings on the RADIUS servers.
The IP addresses of the primary and secondary authentication/authorization servers cannot be the
same. Otherwise, the configuration fails.
Related commands: key, radius scheme, state.
2-10