Dot1X Quiet-Period - 3Com S7906E Command Reference Manual

interface-number represents the port number, and & <1-10> means that you can provide up to 10 port
indexes/port index lists for this argument. The start port number must be smaller than the end number
and the two ports must be of the same type.
Description
Use the dot1x port-method command to set the access control method for specified or all ports.
Use the undo dot1x port-method command to restore the default.
The default access control method is macbased.
Related commands: display dot1x.
Examples
# Set the access control method to portbased for port GigabitEthernet 2/0/1.
<Sysname> system-view
[Sysname] dot1x port-method portbased interface GigabitEthernet 2/0/1
Or
<Sysname> system-view
[Sysname] interface GigabitEthernet 2/0/1
[Sysname-GigabitEthernet2/0/1] dot1x port-method portbased

dot1x quiet-period

Syntax
dot1x quiet-period
undo dot1x quiet-period
View
System view
Default Level
2: System level
Parameters
None
Description
Use the dot1x quiet-period command to enable the quiet timer function.
Use the undo dot1x quiet-period command to disable the function.
By default, the function is disabled.
After a supplicant fails the authentication, the authenticator refuses further authentication requests from
the supplicant in the period dictated by the quiet timer.
Related commands: display dot1x, dot1x timer.
Examples
# Enable the quiet timer.
<Sysname> system-view
1-13