Console Port Login Configuration With Authentication Mode Being Scheme - 3Com Switch 4800G 24-Port Configuration Manual

Console Port Login
Configuration with
Authentication Mode
Being Scheme
Configuration Procedure

Console Port Login Configuration with Authentication Mode Being Scheme

[SW4800G] user-interface aux 0
# Specify to authenticate the user logging in through the console port using the
local password.
[SW4800G-ui-aux0] authentication-mode password
# Set the local password to 123456 (in plain text).
[SW4800G-ui-aux0] set authentication password simple 123456
# Specify commands of level 2 are available to the user logging in to the AUX user
interface.
[SW4800G-ui-aux0] user privilege level 2
# Set the baud rate of the console port to 19,200 bps.
[SW4800G-ui-aux0] speed 19200
# Set the maximum number of lines the screen can contain to 30.
[SW4800G-ui-aux0] screen-length 30
# Set the maximum number of commands the history command buffer can store
to 20.
[SW4800G-ui-aux0] history-command max-size 20
# Set the timeout time of the AUX user interface to 6 minutes.
[SW4800G-ui-aux0] idle-timeout 6
After the above configuration, to ensure a successful login, the console user needs
to change the corresponding configuration of the terminal emulation program
running on the PC, to make the configuration consistent with that on the switch.
Refer to section "Setting Up the Connection to the Console Port" on page 31 for
more.
To do...
Enter system view
Use the command...
system-view
41
Remarks
-