Hwtacacs Nas-Ip - 3Com S7906E Command Reference Manual

View
Any view
Default Level
2: System level
Parameters
hwtacacs-scheme hwtacacs-scheme-name: Specifies a HWTACACS scheme by its name, a string of
1 to 32 characters.
slot slot-number: Specifies the slot where the interface card is inserted.
Description
Use the display stop-accounting-buffer command to display information about the stop-accounting
requests buffered in the device.
Related commands: reset
stop-accounting.
Examples
# Display information about the buffered stop-accounting requests for HWTACACS scheme hwt1 on
the interface board in slot 1.
<Sysname> display stop-accounting-buffer hwtacacs-scheme hwt1 slot 1
Slot 1
Total 0 record(s) Matched

hwtacacs nas-ip

Syntax
hwtacacs nas-ip ip-address
undo hwtacacs nas-ip
View
System view
Default Level
2: System level
Parameters
ip-address: IP address in dotted decimal notation. It must be an address of the device and cannot be all
0s address, all 1s address, a class D address, a class E address or a loopback address.
Description
Use the hwtacacs nas-ip command to set the IP address for the device to use as the source address of
the HWTACACS packets to be sent to the server.
Use the undo hwtacacs nas-ip command to remove the configuration.
By default, the source IP address of a packet sent to the server is the IP address of the outbound port.
stop-accounting-buffer, stop-accounting-buffer
3-4
enable, retry