Dot1X Port-Control - 3Com S7906E Command Reference Manual

Parameters
None
Description
Use the dot1x multicast-trigger command to enable the multicast trigger function of 802.1X to send
multicast trigger messages to the clients periodically.
Use the undo dot1x multicast-trigger command to disable this function.
By default, the multicast trigger function is enabled.
Related commands: display dot1x.
Examples
# Disable the multicast trigger function for interface GigabitEthernet2/0/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet2/0/1
[Sysname- GigabitEthernet2/0/1] undo dot1x multicast-trigger

dot1x port-control

Syntax
In system view:
dot1x port-control { authorized-force | auto | unauthorized-force } [ interface interface-list ]
undo dot1x port-control [ interface interface-list ]
In Ethernet interface view:
dot1x port-control { authorized-force | auto | unauthorized-force }
undo dot1x port-control
View
System view, Ethernet interface view
Default Level
2: System level
Parameters
authorized-force: Places the specified or all ports in the authorized state, allowing users of the ports to
access the network without authentication.
auto: Places the specified or all ports in the unauthorized state initially to allow only EAPOL frames to
pass, and turns the ports into the authorized state to allow access to the network after the users pass
authentication. This is the most common choice.
unauthorized-force: Places the specified or all ports in the unauthorized state, denying any access
requests from users of the ports.
interface interface-list: Specifies an Ethernet port list, which can contain multiple Ethernet ports. The
interface-list argument is in the format of interface-list = { interface-type interface-number [ to
interface-type interface-number ] } & <1-10>, where interface-type represents the port type,
interface-number represents the port number, and & <1-10> means that you can provide up to 10 port
1-11