Ftp Client Source - 3Com S7906E Command Reference Manual

If you specify the parameters, you will be prompted to enter the username and password for
accessing the FTP server.
The priority of the source address specified with this command is higher than that with the ftp
client source command. If you specify the source address with the ftp client source command
first and then with the ftp command, the source address specified with the ftp command is used to
communicate with the FTP server.
Related commands: ftp client source.
Examples
# Log in from the current device Sysname1 to the device Sysname2 with the IP address of
192.168.0.211. The source IP address of the packets sent is 192.168.0.212.
<Sysname> ftp 192.168.0.211 source ip 192.168.0.212
Trying 192.168.0.211 ...
Press CTRL+K to abort
Connected to 192.168.0.211.
220 FTP Server ready.
User(192.168.0.211:(none)):abc
331 Password required for abc
Password:
230 Login OK
[ftp]

ftp client source

Syntax
ftp client source { interface interface-type interface-number | ip source-ip-address }
undo ftp client source
View
System view
Default Level
2: System level
Parameters
interface interface-type interface-number: Source interface for the FTP connection, including interface
type and interface number. The primary IP address configured on the source interface is the source IP
address of the packets sent by FTP. If no primary IP address is configured on the source interface, the
connection fails.
ip source-ip-address: Source IP address of the FTP connection. It must be an IP address that has been
configured on the device.
Description
Use the ftp client source command to configure the source address of the transmitted FTP packets
from the FTP client.
Use the undo ftp client source command to restore the default.
2-14