Display This - 3Com S7906E Command Reference Manual

display this

Syntax
display this [ by-linenum ]
View
Any view
Default Level
1: Monitor level
Parameters
by-linenum: Specifies to display the number of each line.
Description
Use the display this command to display the validated configuration under the current view.
After finishing a set of configurations under a view, you can use the display this command to check
whether the configuration takes effect.
Note that:
A parameter is not displayed if it has the default configuration.
A parameter is not displayed if the configuration has not taken effect.
When you use the command in a user interface view, the command displays the valid configuration
in all the user interfaces.
When you execute the command in any VLAN view, the command displays configuration of all the
VLANs.
Examples
# Display the valid configuration information of the current view (the output information depends on the
current configuration of the device).
<Sysname> system-view
[Sysname] user-interface vty 0
[Sysname-ui-vty0] display this
#
user-interface aux 0
user-interface vty 0
history-command max-size 256
user-interface vty 1 4
#
return
# Display the valid configuration information on interface Ethernet 2/0/1 (the output information depends
on the current configuration of the device).
<Sysname> system-view
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] display this
#
interface Ethernet2/0/1
1-12