3Com S7906E Command Reference Manual page 1517

Import VPN Targets
Import Route Policy
Description
Maximum number of Routes
Interfaces
domain-id
Syntax
domain-id domain-id [ secondary ]
undo domain-id [ domain-id ]
View
OSPF view
Default Level
2: System level
Parameters
domain-id: OSPF domain ID, in integer or dotted decimal notation. If it is in integer, it ranges from 0 to
4,294,967,295.
secondary: Uses the domain ID as secondary. With this keyword not specified, the domain ID
configured is primary.
Description
Use the domain-id command to configure an OSPF domain ID.
Use the undo domain-id command to restore the default.
By default, the OSPF domain ID is 0.
With no parameter specified, the undo domain-id command deletes all domain IDs.
Usually, routes injected from PEs are advertised as External-LSAs. However, routes to different
destinations in the same OSPF domain must be advertised as Type-3 LSAs. Therefore, using the same
domain ID is required for an OSPF domain.
Examples
# Configure the OSPF domain ID.
<Sysname> system-view
[Sysname] ospf 100 vpn-instance vpn1
[Sysname-ospf-100] domain-id 234
Field
Import target attribute of the VPN instance
Import routing policy of the VPN instance
Description of the VPN instance
Maximum number of routes of the VPN instance
Interface to which the VPN instance is bound
Description
1-13