C-Rp Advertisement-Interval (Ipv6 Pim View) - 3Com S7906E Command Reference Manual

priority: Priority of the C-RP, in the range of 0 to 255 and defaulting to 0. A larger value means a lower
priority.
hold-interval: C-RP timeout time, in seconds. The effective range is 1 to 65,535. If you do not include
this argument in your command, the corresponding global setting will be used.
adv-interval: C-RP-Adv interval in seconds, with an effective range of 1 to 65,535. If you do not include
this argument in your command, the corresponding global setting will be used.
Description
Use the c-rp command to configure the specified interface as a C-RP.
Use the undo c-rp command to remove the related C-RP configuration.
No C-RPs are configured by default.
Note that:
IPv6 PIM-SM must be enabled on the interface to be configured as a C-RP.
If you do not specify an IPv6 multicast group range for the C-RP, the C-RP will serve all IPv6
multicast groups.
If you wish a router to be a C-RP for multiple group ranges, you need to include these group ranges
in multiple rules in the IPv6 ACL corresponding to the group-policy keyword.
If you carry out this command repeatedly on the same interface, the last configuration will take
effect.
Related commands: c-bsr.
Examples
# Configure the interface with the IPv6 address of 2001::1 to be a C-RP for IPv6 multicast group
FF0E:0:1391::/96, with a priority of 10.
<Sysname> system-view
[Sysname] acl ipv6 number 2000
[Sysname-acl6-basic-2000] rule permit source ff0e:0:1391:: 96
[Sysname-acl6-basic-2000] quit
[Sysname] pim ipv6
[Sysname-pim6] c-rp 2001::1 group-policy 2000 priority 10

c-rp advertisement-interval (IPv6 PIM view)

Syntax
c-rp advertisement-interval interval
undo c-rp advertisement-interval
View
IPv6 PIM view
Default Level
2: System level
Parameters
interval: C-RP-Adv interval in seconds, with an effective range of 1 to 65,535.
1-6