Reset Unused Porttag - 3Com S7906E Command Reference Manual

If you do not specify the slot keyword, or reboot the active main board, the execution of the reboot
command results in the reboot of the whole device.
Device reboot may result in the interruption of the ongoing services. Be careful to use these
commands.
If a main boot file fails or does not exist, the device cannot be rebooted with this command. In this
case, you can re-specify a main boot file to reboot the device, or you can power off the device, then
power it on and the system automatically uses the backup boot file to restart the device.
If you are performing file operations when the device is to be rebooted, the system does not
execute the command for the sake of security.
Examples
# If the current configuration does not change, reboot the device.
<Sysname> reboot
Start to check configuration with next startup configuration file, please wait.........DONE!
This command will reboot the device. Continue? [Y/N]:y
Starting......
# If the current configuration changes, reboot the device.
<Sysname> reboot
Start to check configuration with next startup configuration file, please wait.........DONE!
This command will reboot the device. Current configuration will be lost in next startup if
you continue. Continue? [Y/N]:y
Starting......

reset unused porttag

Syntax
reset unused porttag
View
User view
Default Level
1: Monitor level
Parameters
None
Description
Use the reset unused porttag command to clear the 16-bit index saved but not used in the current
system.
A confirmation is required when you carry out this command. If you fail to make a confirmation within 30
seconds or enter "N" to cancel the operation, the command will not be carried out.
1-23