3Com S7906E Command Reference Manual page 1983

stopbits
Syntax
stopbits { 1 | 1.5 | 2 }
undo stopbits
View
AUX interface view
Default Level
2: System level
Parameters
1: Sets the stop bits to 1.
1.5: Sets the stop bits to 1.5.
2: Sets the stop bits to 2.
Description
Use the stopbits command to set the stop bits of the user interface.
Use the undo stopbits command to revert to the default stop bits.
By default, the stop bits is 1.
The stopbits cannot be 1.5 on an S7900E series Ethernet switch.
Examples
# Set the stop bits to 2.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface aux 0
[Sysname-ui-aux0] stopbits 2
telnet
Syntax
telnet remote-system [ port-number ] [ source { ip ip-address | interface interface-type
interface-number } ]
View
User view
1-22