State-Refresh-Interval (Ipv6 Pim View); State-Refresh-Rate-Limit (Ipv6 Pim View) - 3Com S7906E Command Reference Manual

Related commands:
state-refresh-rate-limit.
Examples
# Set the hop limit value of state refresh messages to 45.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] state-refresh-hoplimit 45

state-refresh-interval (IPv6 PIM view)

Syntax
state-refresh-interval interval
undo state-refresh-interval
View
IPv6 PIM view
Default Level
2: System level
Parameters
interval: State refresh interval in seconds, with an effective range of 1 to 255.
Description
Use the state-refresh-interval command to configure the interval between state refresh messages.
Use the undo state-refresh-interval command to restore the system default.
By default, the state refresh interval is 60 seconds.
Related commands:
state-refresh-hoplimit.
Examples
# Set the state refresh interval to 70 seconds.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] state-refresh-interval 70

state-refresh-rate-limit (IPv6 PIM view)

Syntax
state-refresh-rate-limit interval
undo state-refresh-rate-limit
View
IPv6 PIM view
pim ipv6 state-refresh-capable,
pim ipv6 state-refresh-capable,
1-46
state-refresh-interval,
state-refresh-rate-limit,