Telnet Server Enable - 3Com S7906E Command Reference Manual

Description
Use the telnet client source command to specify the source IP address or source interface for the
Telnet packets to be sent.
Use the undo telnet client source command to remove the source IP address or source interface
configured for Telnet packets.
By default, source IP address or source interface of the Telnet packets sent is not configured.
Examples
# Specify the source IP address for Telnet packets.
<Sysname> system-view
[Sysname] telnet client source ip 129.102.0.2
# Remove the source IP address configured for Telnet packets.
[Sysname] undo telnet client source

telnet server enable

Syntax
telnet server enable
undo telnet server enable
View
System view
Default Level
3: Manage level
Parameters
None
Description
Use the telnet server enable command to make the switch to operate as a Telnet Server.
Use the undo telnet server enable command disable the switch from operating as a Telnet server.
By default, a switch does not operate as a Telnet server.
Examples
# Make the switch to operate as a Telnet Server.
<Sysname> system-view
[Sysname] telnet server enable
% Start Telnet server
# Disable the switch from operating as a Telnet server.
[Sysname] undo telnet server enable
% Close Telnet server
1-25