Display Igmp-Snooping Statistics - 3Com S7906E Command Reference Manual

Subvlan flags: R-Real VLAN, C-Copy VLAN
Router port(s)
( 00:01:30 )
IP group address
(0.0.0.0, 224.1.1.1)
MAC group address
Attribute
Host port(s)

display igmp-snooping statistics

Syntax
display igmp-snooping statistics
View
Any view
Default Level
1: Monitor level
Parameters
None
Description
Use the display igmp-snooping statistics command to view the statistics information of IGMP
messages learned by IGMP Snooping.
Examples
# View the statistics information of IGMP messages learned by IGMP Snooping.
<Sysname> display igmp-snooping statistics
Received IGMP general queries:0.
Received IGMPv1 reports:0.
Received IGMPv2 reports:19.
Received IGMP leaves:0.
Received IGMPv2 specific queries:0.
Sent IGMPv2 specific queries:0.
Field
1-3
Description
Sub-VLAN flags: R for real egress sub-VLAN
under the current entry, C for sub-VLAN copied
from a (*, G) entry to an (S, G) entry
Number of router ports
Remaining time of the dynamic member port or
router port aging timer. On a distributed device,
to get this time value of a non-aggregation port
that does not belong to the SRPU, you must
specify the number of the slot where the
corresponding board resides; this is not required
on an aggregation port.
Address of IP multicast group
An (S, G), where 0.0.0.0 implies any multicast
source
Address of MAC multicast group
Attribute of IP multicast group
Number of member ports