3Com S7906E Command Reference Manual page 1763

Parameters
disable: Disables the idle cut function.
enable minute: Enables the idle cut function. The minute argument refers to the allowed idle duration, in
the range 1 to 120 minutes.
Description
Use the idle-cut command to enable or disable the idle cut function.
By default, the function is disabled.
Related commands: domain.
Examples
# Enable the idle cut function and set the idle threshold to 50 minutes for ISP domain aabbcc.net.
<Sysname> system-view
[Sysname] domain aabbcc.net
[Sysname-isp-aabbcc.net] idle-cut enable 50
level
Syntax
level level
undo level
View
Local user view
Default Level
3: Manage level
Parameters
level: Level of the user, which can be 0 for visit level, 1 for monitor level, 2 for system level, and 3 for
manage level. A smaller number means a lower level.
Description
Use the level command to set the level of a user.
Use the undo level command to restore the default.
By default, the user level is 0.
Note that:
If you specify not to perform authentication or use password authentication, the level of the
commands that a user can use after logging in depends on the level of the user interface. For
details about the authentication, refer to command authentication-mode in User Interface
Commands of the System Volume.
If you specify an authentication method that requires the username and password, the level of the
commands that a user can use after logging in depends on the level of the user. For an SSH user
using RSA public key authentication, the commands that can be used depend on the level
configured on the user interface.
1-22