Overflow-Replace (Mld-Snooping View); Report-Aggregation (Mld-Snooping View) - 3Com S7906E Command Reference Manual

[Sysname-vlan2] mld-snooping version 2

overflow-replace (MLD-Snooping view)

Syntax
overflow-replace [ vlan vlan-list ]
undo overflow-replace [ vlan vlan-list ]
View
MLD-Snooping view
Default Level
2: System level
Parameters
vlan vlan-list: Defines one or multiple VLANs. You can provide up to 10 VLAN lists, by each of which
you can specify an individual VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id to
end-vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The effective range of a
VLAN ID is 1 to 4094.
Description
Use the overflow-replace command to enable the IPv6 multicast group replacement function globally.
Use the undo overflow-replace command to disable the IPv6 multicast group replacement function
globally.
By default, the IPv6 multicast group replacement function is disabled globally.
Note that:
This command works on both MLD Snooping–enabled VLANs and VLANs with MLD enabled on
their VLAN interfaces.
If you do not specify any VLAN, the command will take effect for all VLANs; if you specify a VLAN or
multiple VLANs, the command will take effect for the specified VLAN(s) only.
Related commands: mld-snooping overflow-replace.
Examples
# Enable the IPv6 multicast group replacement function globally in VLAN 2.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] overflow-replace vlan 2

report-aggregation (MLD-Snooping view)

Syntax
report-aggregation
undo report-aggregation
View
MLD-Snooping view
1-24