Last-Listener-Query-Interval (Mld View) - 3Com S7906E Command Reference Manual

Last-listener-query-timer-expiry: off
Table 1-6 display mld ssm-mapping group command output description
Interface group report information
Total 1 MLD SSM-mapping Group reported
Group
Uptime
Expires
Last reporter
Group mode
Source list(Total 1 source)
Source
Last-listener-query-counter
Last-listener-query-timer-expiry

last-listener-query-interval (MLD view)

Syntax
last-listener-query-interval interval
undo last-listener-query-interval
View
MLD view
Default Level
2: System level
Parameters
interval: MLD last listener query interval in seconds, namely the length of time the device waits between
sending MLD multicast-address-specific queries. The effective range is 1 to 5.
Description
Use the last-listener-query-interval command to configure the MLD last listener query interval
globally.
Use the undo last-listener-query-interval command to restore the system default.
Field
1-9
Description
IPv6 multicast group information created based
on MLD SSM mappings on the interface
One MLD SSM mapping multicast group was
reported.
IPv6 multicast group address
Length of time since the IPv6 multicast group
was reported
Remaining time of the IPv6 multicast group ,
where "off" means that the group never times out
IPv6 address of the host that last reported
membership for this group
IPv6 multicast sources filter mode
IPv6 multicast source list (one IPv6 multicast
source)
IPv6 multicast source address
Number of MLD multicast-address-specific
queries sent
Remaining time of the MLD last listener query
timer , where "off" means that the timer never
expires