Tunnel Select-Seq Load-Balance-Number - 3Com S7906E Command Reference Manual

Parameters
tunnel-policy-name: Name for the tunneling policy, a string of 1 to 19 characters.
Description
Use the tunnel-policy command to establish a tunneling policy and enter tunneling policy view.
Use the undo tunnel-policy command to delete a tunneling policy.
Related commands: tunnel select-seq load-balance-number.
Examples
# Establish a tunneling policy named po1 and enter tunneling policy view.
<Sysname> system-view
[Sysname] tunnel-policy po1
[Sysname-tunnel-policy-po1]

tunnel select-seq load-balance-number

Syntax
tunnel select-seq { cr-lsp | lsp } * load-balance-number number
undo tunnel select-seq
View
Tunneling policy view
Default Level
2: System level
Parameters
cr-lsp: Specifies CR-LSP tunnels.
lsp: Specifies LSP tunnels.
number: Number of tunnels for load balancing, in the range 1 to 4.
Description
Use the tunnel select-seq load-balance-number command to configure the preference order for
tunnel selection and the number of tunnels for load balancing.
Use the undo tunnel select-seq command to restore the default.
The S7900E series switches do not support CR-LSP tunnels. You can configure load balancing for only
LSP tunnels.
By default, one LSP tunnel can be used. That is, only LSP tunnels can be used and the number of
tunnels for load balancing is 1.
1-61