Reset Mld-Snooping Group - 3Com S7906E Command Reference Manual

Default Level
2: System level
Parameters
None
Description
Use the mld-snooping report-aggregation command to enable MLD report suppression.
Use the undo mld-snooping report-aggregation command to disable MLD report suppression.
By default, MLD report suppression is enabled.
This command works on both MLD Snooping–enabled VLANs and VLANs with MLD enabled on their
VLAN interfaces.
Examples
# Disable MLD report suppression.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] undo report-aggregation

reset mld-snooping group

Syntax
reset mld-snooping group { ipv6-group-address | all } [ vlan vlan-id ]
View
User view
Default Level
2: System level
Parameters
ipv6-group-address: Clears the information about the specified multicast group. The effective range of
ipv6-group-address is FFxy::/16 (excluding FFx0::/16, FFx1::/16, FFx2::/16 and FF0y::), where x and y
represent any hexadecimal number between 0 and F, inclusive.
all: Clears all MLD Snooping multicast group information.
vlan vlan-id: Clears the MLD Snooping multicast group information in the specified VLAN. The effective
range of vlan-id is 1 to 4094.
Description
Use the reset mld-snooping group command to clear MLD Snooping multicast group information.
Note that:
This command works only on MLD Snooping–enabled VLANs, but not on VLANs with MLD
enabled on their VLAN interfaces.
This command cannot clear MLD Snooping multicast group information of static joining.
1-25