Igmp-Snooping Router-Aging-Time - 3Com S7906E Command Reference Manual

This command takes effect only if IGMP Snooping is enabled in the VLAN.
Related commands:
max-response-time, max-response-time.
Examples
# Enable IGMP Snooping and set the interval between IGMP general queries to 20 seconds in VLAN 2.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping query-interval 20

igmp-snooping router-aging-time

Syntax
igmp-snooping router-aging-time interval
undo igmp-snooping router-aging-time
View
VLAN view
Default Level
2: System level
Parameters
interval: Dynamic router port aging time, in seconds. The effective range is 1 to 1,000.
Description
Use the igmp-snooping router-aging-time command to configure the aging time of dynamic router
ports in the current VLAN.
Use the undo igmp-snooping router-aging-time command to restore the default setting.
By default, the aging time of dynamic router ports is 105 seconds.
This command takes effect only if IGMP Snooping is enabled in the VLAN.
Related commands: igmp-snooping enable, router-aging-time.
Examples
# Enable IGMP Snooping and set the aging time of dynamic router ports to 100 seconds in VLAN 2.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping router-aging-time 100
igmp-snooping enable,
1-19
igmp-snooping querier, igmp-snooping