Reset Multicast Ipv6 Forwarding-Table - 3Com S7906E Command Reference Manual

Description
Use the multicast ipv6 routing-enable command to enable IPv6 multicast routing.
Use the undo multicast ipv6 routing-enable command to disable IPv6 multicast routing.
IPv6 multicast routing is disabled by default.
Note that:
You must enable IPv6 multicast routing before you can carry out other Layer 3 IPv6 multicast
commands.
The device does not forward any IPv6 multicast packets before IPv6 multicast routing is enabled.
Examples
# Enable IPv6 multicast routing.
<Sysname> system-view
[Sysname] multicast ipv6 routing-enable

reset multicast ipv6 forwarding-table

Syntax
reset multicast ipv6 forwarding-table { { ipv6-source-address [ prefix-length ] | ipv6-group-address
[ prefix-length ] | incoming-interface { interface-type interface-number | register } } * | all }
View
User view
Default Level
2: System level
Parameters
ipv6-source-address: IPv6 multicast source address.
ipv6-group-address: IPv6 multicast group address, in the range of FFxy::/16, where x and y represent
any hexadecimal number from 0 to F.
prefix-length: Prefix length of an IPv6 multicast group or an IPv6 multicast source address. For an IPv6
multicast group address, this argument has an effective value range of 8 to 128; for an IPv6 multicast
source address, this argument has an effective value range of 0 to 128. The system default is 128 in
both cases.
incoming-interface: Specifies to clear IPv6 multicast forwarding entries of which the incoming
interface is the specified one.
interface-type interface-number: Specifies an interface by its name and number.
register: Specifies the register interface.
all: Clears all forwarding entries from the IPv6 multicast forwarding table.
Description
Use the reset multicast ipv6 forwarding-table command to clear forwarding entries from the IPv6
multicast forwarding table.
1-11