Mpls L3Vpn Configuration Commands; Default Local-Preference (Bgp-Vpnv4 Subaddress Family View) - 3Com S7906E Command Reference Manual

1

MPLS L3VPN Configuration Commands

For information about BGP L2VPN address family, refer to MPLS L2VPN Configuration in the MPLS
Volume.
MPLS L3VPN Configuration Commands

default local-preference (BGP-VPNv4 subaddress family view)

Syntax
default local-preference value
undo default local-preference
View
BGP-VPNv4 subaddress family view
Default Level
2: System level
Parameters
value: Default value for the local preference, in the range 0 to 4294967295. A greater value represents
a higher priority.
Description
Use the default local-preference command to set the default value of the local preference.
Use the undo default local-preference command to restore the default.
By default, the default value of the local preference is 100.
Examples
# With devices A and B connected to the outside AS, configure B with a default local preference of 180
in BGP-VPNv4 subaddress family view, allowing the route going through B to be preferred when more
than one route is present.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv4-family vpnv4
[Sysname-bgp-af-vpnv4] default local-preference 180
1-1