Xerox DocuColor 250 Online Help Manual page 71

P r od u c t Na me Bo o k N am e
Size is selected, there is the ability to specify the amount of
white space around the outside of the imposed output, or
outside margin. Like the gutter, the user will specify one
outside margin amount, which will be applied as the minimum
allowable amount of white space along the exterior of the
imaged area on all four sides. Depending on various factors,
such as scale percentage, image size, gutter, there may exist
more outside margin than is programmed. Unlike gutter, the
outside margin is the actual amount of white space on the
output sheet, and NOT relative to the unscaled original
document size. If the user programs an outside margin of 1",
there will exist at least 1" of white space on edge of all four
sides of the output sheet.
• Bleed/Trim Size
More Information...
For all layout styles, there is the ability to specify the existence
of image bleed in the original document. If bleed is specified,
the user needs to specify the trim size. The trim size is the trim
size of the original document, not the trim size of the imposed
image after reduction or enlargement. If the user specifies a
trim size greater than the automatically detected original
document size, the image will be centered within the larger
trim box. The existence of bleed and trim size will also be used
to place crop marks on the output sheet. Crop marks, when
specified, will be placed around the edges of the Trim Box.
When gutter and/or outside margin are specified along with
bleed, the bleed image will appear within the gutter and/or
outside margin white space, with the appropriate crop marks,
when applied.
• Remove Image Bleed
More Information...
When bleed and trim size are programmed for signature-style
layouts (Saddle Stitch and Perfect Booklet), there will be the
ability to specify the amount of image bleed to remove along
the center fold line of the signature output sheet. The user will
be given two options on how to deal with the bleed along the
fold line (bleed mode); they can select Bleed to Fold or set a
custom bleed amount. When Bleed to Fold is selected, the
entire bleed area will be removed from the right edge of the
left-hand image and the entire bleed area will be removed from
the left edge of the right-hand image, along the center fold line.
This will have the effect of bringing the two image trim boxes
flush with each other along the fold. If custom bleed is
selected, there user can specify manually the amount of bleed
area to be removed from each image along the center fold
line, in effect moving each of the trim boxes inwards towards
the fold line by the specified amount. Important to note is that,
like gutter, the custom bleed amount is relative to the unscaled
original document size. Bleed for signature jobs and gutters
are mutually exclusive. If bleed is selected, gutter will not be
-53