Xerox DocuColor 250 Online Help Manual page 315

P r od u c t Na me Bo o k N am e
6. From the Layout pull-down menu, select one of the signature
booklet options:
• Booklet
• Perfect Booklet
7. Select the Stapling/Finishing FAB.
8. Select the SBM from the Output Location pull-down menu.
9. Select [OK] to save settings and return to the Job Manager
main window.
10. Right-click on the job and select [Release].
How do I convert a signature job to standard, and a standard
job to signature?
If you wish to convert a standard job to signature, simply follow the
instructions in this section: How do I program a booklet/signature
job? However, if you wish to convert a signature job to standard,
this must be done by editing the original job at the client
workstation prior to resubmission to the DocuSP controller.
How do I adjust the bleed edge of a job?
1. Open the Job Manager.
2. Double-click the job you wish to edit. The Job Properties
window opens.
3. Choose the Output tab.
4. Select the Layout FAB.
5. From the Layout Style menu, select [Booklet] or [Perfect
Booklet].
6. Select [Setup...].
7. Select from the following:
• Bleed/Trim Size
• More Information...
• For all layout styles, there will be the ability to specify the
existence of image bleed in the original document. If bleed
is specified, the user need to specify the trim size. The trim
size is the trim size of the original document, not the trim
size of the imposed image after reduction or enlargement.
If the user specifies a trim size greater than the
automatically detected original document size, the image
will be centered within the larger trim box. The existence of
bleed and trim size will also be used to place crop marks
on the output sheet. Crop marks, when specified, will be
placed around the edges of the Trim Box. When gutter
and/or outside margin are specified along with bleed, the
bleed image will appear within the gutter and/or outside
margin white space, with the appropriate crop marks, when
-15