Xerox DocuColor 250 Online Help Manual page 311

P r od u c t Na me Bo o k N am e
3. Set the Scheduling Mode: The Scheduling Mode is used to
specify how jobs that require unavailable paper stock or
finishing options are handled by the system. Choose from the
following: Only System Administrators can change this setting.
• Resource Based Scheduling: The system determines if
the resources needed to print the job are available. If
resources needed for printing are not available, the job is
identified as ineligible and the system continues to RIP and
print other jobs. Once the required resources that made
the job ineligible become available, the job is scheduled
and released to print.
• FIFO (First In First Out): FIFO jobs are scheduled and
printed in the order they were initiated on the system. If the
print job requires a "soft" resource, such as a stock needs
to be loaded or, the stock tray is disabled, the system
raises a function fault and suspend printing. If a print job
requires a "hard" resource, such as stapler disabled or,
binder is off, the system faults the job and continue printing
other jobs.
4. Select [OK].
How do I delete a job?
Deleting a job removes the job from the system.
To delete a job:
1. Open Job Manager.
2. Click on any listed job.
3. Delete the job by performing one of the following:
• Right-click the job and select [Delete].
• Select a job and choose [Delete] form the Job menu.
• Select the [Delete] icon from the toolbar.
4. Select [Yes] to remove the job from the system.
How do I pause and resume a printer?
When a job is paused it stops the printing or scanning process.
Consider pausing the printer instead of holding jobs when you
need to make an adjustment, such as changing the toner. Paused
jobs do not process again. When a job is held it needs to process
again before it can be printed.
To pause and resume a job:
1. From the Content menu select [Pause], which is located in the
upper right corner of the main GUI screen.
2. To resume the printing process select [Resume].
-11