Xerox DocuColor 250 Online Help Manual page 240

- 16
• IBM Network Printer Manager (for NT)
• Novell Managewise (for NT)
• TNG Unicenter (for NT)
• HP OpenView (for UNIX and NT)
• Xerox CentreWare (for UNIX and NT)
Accessing SNMP settings
To access SNMP settings:
1. Logon to the DocuSP Controller as a System Administrator.
2. From the Setup menu, select [Gateways...].
3. Select the SNMP tab.
Enabling SNMP
To enable SNMP:
1. Logon to the DocuSP Controller as a System Administrator.
2. From the Setup menu, select [Gateways...].
3. Select the SNMP tab.
4. Mark the [Enabled] check box.
5. Place a check mark in the [Enable Authentication Traps] if you
want to receive notification of authentication events at the
device.
6. Accept the default name or type a new name in the text box for
Read Community String. This is the password for SNMP Get
requests issued by the SNMP Manager to the Agent.
7. Accept the default name or type a new name in the text box for
Write Community String. This is the password for SNMP Set
requests issued by the SNMP Manager to the Agent.
CAUTION: If you change the Read (Get) and Write (Set)
Community Strings, you must also change the strings used by all
network applications communicating by SNMP with this Agent.
8. Accept the default name or type a new name in the text box for
Trap Community String. This is the password for SNMP Traps
sent by the Agent to the SNMP Manager.
9. Select [OK] or [Apply] to save settings.
Configuring or Viewing SNMP Serial Numbers
The status of components can be reported by serial numbers.
Components with serial numbers include feeders, trays, and
stackers.
To configure or view SNMP serial numbers:
1. Logon to the DocuSP Controller as a System Administrator.
P r o du c t N am e B o ok N am e