Xerox DocuColor 250 Online Help Manual page 52

- 34
Outside Margin for more information.
NOTE: If mm is selected under Units, the metric values will
be displayed instead of English values.
c. Set the Trim Size if you wish to leave bleed edges around
your images. You can select the radio button for "Smaller
Than Original Image" to activate the Width and Height spin
boxes. See Bleed/Trim Size for more information.
d. Set the Bleed Mode to Custom if desired. The default
Bleed Mode is Bleed To Fold, but you can set a Custom
Bleed Mode between 0.00" and 2.00." See Remove Image
Bleed for more information.
e. If desired, select the pull-down menu for Crop Marks and
select from the following options:
– None: prints no crop marks
– Front
– Back: appears only if Sides Imaged is set to 2
– Both Front and Back: appears only if Sides Imaged is
set to 2
See Crop Marks for more information.
f. If desired, select the units in [mm] or [inches].
g. When all settings have been made, select [OK]. Your
selections will be displayed in the text field.
8. You may also set up a custom layout style, using an existing
layout and including all the specific advanced settings you
have chosen. To set up a custom template:
a. Make all desired settings to your chosen layout style, as in
steps 6-8 above.
b. Select [Save As...]. The Save As User-Defined Template
window opens.
c. Within the Template Name text field, enter a descriptive
name for the User-Defined Template. You may save a
template with the same name as a previously existing
user-defined template; in this case the newly saved
template overwrites the older one. However, you cannot
overwrite any of the preinstalled templates. If you try to do
so, an error message will appear.
NOTE: You must be logged on to the controller as
'operator' or 'System Administrator' to set up a custom
layout style.
9. Select [OK] to commit changes and exit the Layout Setup
window.
10. Select [OK], or continue setting job properties.
P r o du c t N am e B o ok N am e