Xerox DocuColor 250 Online Help Manual page 133

P r od u c t Na me Bo o k N am e
NOTE: Booklet making is supported for Letter/A4 Short
Edge Feed, Legal, 8.5" x 13", and Ledger/A3. Letter/A4
Short Edge Feed must be used for folding. Booklet making
cannot be performed using transparencies, pre-cut tabs, or
labels. Folding cannot be performed using transparencies,
pre-cut tabs, labels, or coated stock.
4. Output order determines the order in which the printed pages
are delivered to an output device, either first to last or last to
first. Specifying the output order is important for certain types
of finishing. Select from the following options:
• System Specified: Allows the system to determine the
most appropriate order for the given job.
• 1 - N (Ascending): Printed pages are delivered first to last
with the last page on top.
• N - 1 (Descending): Printed pages are delivered last to
first with the first page on top.
5. Output delivery determines whether the prints will be delivered
face up or face down. Output delivery is useful for retrieving
the printed output in a specific order or for use with certain
types of finishing. Select from the following options:
• System-specified: The system determines the most
appropriate delivery option for the job.
• Face Up: Printed documents are delivered face up.
• Face Down: Printed documents are delivered face down.
6. If desired, select an offset from the Offset pull-down menu:
• None: Offset is not performed. This is the default selection.
• Each Collated Set: The offset will occur between each set
printed.
• Each Uncollated Stack: The offset will occur between
each stack printed.
• Each Set and Stack: The offset will occur between each
set and stack printed.
NOTE: Offset options are available only if the Output
Location selection can handle offset stacking.
7. Offset Subset inserts an offset within a stack (uncollated set)
after each specified page number. Select [Offset Subset] and
set Pages Per Subset values. Offset Subset is only made
available if the Stapling/Finishing selection is None.
8. The Finishing checkbox becomes available for all Stapling/
Finishing selections except None. Select [Finishing] and set
Pages Per Subset values.
Using the Slip Sheets FAB
Slip Sheets are pieces of paper (or other media) that are inserted
-27