Xerox DocuColor 250 Online Help Manual page 302

General job programming tasks
- 2
– How do I print a saved job?
– How do I delete a job?
– How do I pause and resume a printer?
– How do I pause and resume a printer?
• Job layout and finishing
– How do I print a job in reverse order?
– How do I print a job head-to-toe?
– How do I print a 2-up job head-to-toe?
– How do I print letter size on larger paper?
– How do I print 5.5 x 8.5 duplex?
– How do I program job finishing?
– How do I program a booklet/signature job?
– How do I convert a signature job to standard, and a
standard job to signature?
– How do I adjust the bleed edge of a job?
– How do I change stitch/staple placement?
– How do I insert a range of pages before a specified page?
– How do I add inserts to a 2-up or signature job?
– How do I perform a multi-page crop?
– How do I add slip sheets?
– How do I select offset stacking?
– How do I invert a page when I copy a job?
– How do I add and program covers?
– How do I add and program inserts?
After a job has arrived at the DocuSP controller, you may choose
to make a wide variety of settings in order to get your job to print
exactly as you wish it to appear. You may wish to change job
properties, make image quality adjustments, program stocks, and
set up or turn off banner pages. These operations are detailed
below.
How do I change job properties?
To change job properties:
1. Open the Job Manager.
2. Double-click the job whose properties you wish to adjust.
3. Access the various tabs containing settings you wish to
change.
P r o du c t N am e B o ok N am e