Xerox DocuColor 250 Online Help Manual page 230

Open PrePress Interface
- 6
5. Select [OK] to exit the setup dialog.
Printing system configuration information
You may print information from each tab within the System
Configuration tabset.
To print information from the tabs:
1. Select [System Configuration...] from the DocuSP Setup
menu.
2. Select the Peripherals, General, Printer, Devices, Network, or
Software tabs.
3. Select the [Print] button.
4. A dialog will appear. Select the desired queue from the pull-
down menu.
5. Select [OK]. The job is submitted to the queue.
Use the Open PrePress Interface to replace low-resolution proxy
images with high-resolution images when the job is decomposed.
This is useful because low-resolution images transmit much
quicker than high-resolution jobs from the client to the controller.
Once received, the controller can then access the high-resolution
image during decomposition to be used for print.
The repository may reside on the network and may be accessed
via a network mount point, or it may reside on an external hard
drive mounted by DocuSP. Such a drive will generally have better
transfer performance than a traditional network drive point, as the
SCSI transfer rate is faster than the network transfer rate.
OPI can be enabled at the queue level or at the job level; the
following procedure is provided to enable you to set the path to
your image repository.
NOTE: This is only available for PostScript and data streams.
NOTE: If you do not have a valid PostScript license, the system
does not process PostScript jobs.
Using Open PrePress Interface
To configure OPI:
1. Select [Open Prepress Interface...] from the Setup menu. The
OPI Configuration window displays.
2. To map the path to and from the OPI image folder, select
[Add...] in the Path Mapping field. The Add Path Mapping
window opens.
a. Type the name of the path from client to server in the From
P r o du c t N am e B o ok N am e