Xerox DocuColor 250 Online Help Manual page 70

- 52
simple, 4-page job on Letter stock: Page 1 is on the front of
sheet 1 and Page 2 is on the back of sheet 1. Page 3 is on the
front of sheet 2 and Page 4 is on the back of sheet 2. If we
wanted to make this a signature booklet, Page 4 would be
placed (by the template) on the left side of the landscape front
of the output stock, and Page 1 would be placed on the right
side of the front. Page 2 would be placed on the left side of the
back and Page 3 would be placed on the right side of the back.
The booklet would be folded down the middle, and Page 1
would be on the front of the booklet, with Pages 2 and 3 inside
and Page 4 on the back of the booklet.
Notes:
– Scaling: auto-size, default scale (100%), or select
scale percentage
– If the images are too large to fit on the selected stock,
the system faults the job with an error message.
– There is no white space between the images in the
center spread.
– Crop marks, if selected, print at the outside edges, not
between images, and can only be selectable when
auto-size is not selected.
– Bleed image beyond the Original Size will print both on
the outside edges and in the gutter when Signature
Shift is checked.
Advanced Settings for Layouts
• Gutter
More Information...
For all layout styles other than 1-Up, DocuSP provides the
ability to program the amount of white space, or gutter,
between imposed images. The user will specify one gutter
amount which will be applied in both the X and Y directions (if
there are enough images on the imposed page to warrant
gutter in both directions). This gutter amount will be relative to
the unscaled original document size. For example, assume an
original US Letter (8.5x11) document, programmed for 2-Up
imposition on US Letter output stock, with 50% reduction
scaling. If a gutter of 1" is programmed, since the original
document image will be reduced by 50%, the gutter will be
reduced by 50% as well, leaving an actual .5" gutter between
images. When crop marks are programmed in conjunction with
gutter, the marks will be placed along the exterior of the
imaged area on both sides of the gutter.
• Outside Margin
More Information...
When custom multiple-up imposition is specified or when Auto
P r o du c t N am e B o ok N am e