Figure 77. Assembling the node sleeve
After this task is completed
To reinstall the node to the DIN rail, see
Install a node to the DIN rail
Follow instructions in this section to install a node to the DIN rail.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read
"Installation Guidelines" on page 47
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Reserve 500 mm of clearance in front of the node for installation/removal procedure.
Note: Depending on the model, your server might look slightly different from the illustration.
Procedure
"Install a node to the DIN rail" on page
and
"Safety inspection checklist" on page 48
54.
89.
.
Chapter 5
Hardware replacement procedures
to ensure that you
89