Figure 287. Routing the cables
Step 5.
Secure the riser assembly to the node.
a.
Tighten the three captive screws on the top of the riser assembly.
b.
Tighten the three screws on both sides of the node.
c.
Tighten the two thumbscrews in the front of the riser assembly.
Figure 288. Securing the riser assembly
Step 6.
Bundle the riser assembly cables together with a velcro strap; then, push the bundled cables
toward the riser card.
Note: To make sure adequate system cooling, the cables should be routed away from the space
for PMB air baffle.
ThinkEdge SE360 V2 User Guide
268