Table of Contents
Advertisement
Figure 84. Installing the node sleeve
Step 9.
Connect the power cable and other necessary external cables to the node.
Step 10. Power on the server and any peripheral devices. See
Step 11. (Optional) If necessary, install the security bezel.
Note: When the security bezel is installed, the front operator panel and USB Type-C connectors
are not accessible.
a.
Insert the tab of security bezel into the slot; then, pivot the security bezel toward the node
sleeve until the other side of security bezel clicks into place.
Note: Make sure that the external cables in front of the node go through the corresponding
openings of the security bezel.
b.
Lock the security bezel with the key, and store the key for future use.
Figure 85. Installing the security bezel
"Power on the server" on page
.
Chapter 5
Hardware replacement procedures
53.
93
Advertisement
Table of Contents
Troubleshooting
