Figure 284. Routing the cables
Step 5.
Secure the riser assembly to the node.
a.
Tighten the three captive screws on the top of the riser assembly.
b.
Tighten the three screws on both sides of the node.
c.
Tighten the two thumbscrews in the front of the riser assembly.
Figure 285. Securing the riser assembly
Step 6.
Push the Backplane 1 power cable toward the power module board.
Note: To make sure adequate system cooling, the cables should be routed away from the space
for PMB air baffle.
After this task is completed
Complete the parts replacement. See
Demo Video
Watch the procedure on YouTube
"Complete the parts replacement" on page
324.
.
Chapter 5
Hardware replacement procedures
265