Table of Contents
Advertisement
d.
Hold the M.2 drive at an angle, and insert the drive into the M.2 slot.
e.
Lower the rear side of the M.2 drive down to the M.2 adapter.
f.
Secure the M.2 drive with one screw.
Figure 261. Installing an M.2 drive
Note: If necessary, repeat this procedure to other M.2 drives to be installed.
Step 2.
Install the M.2 riser card to the riser cage.
a.
Align the riser card with the guide pins on the riser cage; then, insert and slide the riser card
downward until the guide pins are seated in the small opening of the keyholes.
b.
Secure the riser card with two screws.
Figure 262. Installing the riser card
Step 3.
Install the M.2 adapter to the riser cage.
a.
Align the M.2 adapter with the slot; then, slide the adapter into the slot until it is firmly
seated.
b.
Tighten two screws to the top side of the M.2 adapter.
c.
Tighten one screw to the bottom side of the M.2 adapter.
.
Chapter 5
Hardware replacement procedures
245
Advertisement
Table of Contents
Troubleshooting
