Table of Contents
Advertisement
Figure 100. Installing a drive filler
Step 4.
Insert the bezel; then, fasten the captive screw to secure the bezel.
Figure 101. Installing the bezel
After this task is completed
1. If SED encryption is enabled on the system, reboot the system.
Note: When SED encryption is enabled, rebooting the system is required after installing a drive; without
rebooting, the drive will not be recognized by the host OS.
2. Check the drive status LED to verify that the drive is operating correctly.
• If the yellow drive status LED of a drive is lit continuously, the drive is malfunctioning and must be
replaced.
• If the green drive activity LED is flashing, the drive is functioning.
Demo Video
ThinkEdge SE360 V2 User Guide
104
Advertisement
Table of Contents
Troubleshooting
