Lenovo ThinkEdge SE360 V2 User Manual page 34

Table 5. Components on the rear view
"Rear operator panel" on page 24
1
"RJ-45 RS-232 serial console connector" on page 24
2
"PMB status LED" on page 24
3
"Threaded studs for grounding" on page 24
4
"Lock hole for Kensington lock" on page 24
5
1 Rear operator panel
See "Rear operator panel LEDs" on page 376
RJ-45 RS-232 serial console connector
2
Connect an external RJ-45 serial COMM console cable to this RS-232 serial console with RJ-45 connector.
3 PMB status LED
See "PMB status LED" on page 375
4 Threaded studs for grounding
Connect the grounding wires to these lugs.
5 Lock hole for Kensington lock
Install Kensington lock in this lock hole to secure the server.
6 7 Power connectors
Connect DC power source to these connectors. Make sure the power source is connected properly.
If applicable, before connecting DC power source to the server, remove the header from the corresponding
power connector.
1. Loosen the two captive screws that secure the header; then, remove the header from the power
connector.
Figure 7. Removing the header
2. Store the header for future use.
ThinkEdge SE360 V2 User Guide
24
"Power connector 1" on page 24
6
"Power connector 2" on page 24
7
"x86 WLAN antennas" on page 25
8
"XCC WLAN antennas" on page 25
9
for more information.
for more information.