Lenovo ThinkEdge SE360 V2 User Manual page 18

Electrical input
The models with DC/DC power module board (Output 12V): one of the following
Note: If applicable, before connecting DC power source to the server, remove the header from the corresponding
power connector. See "Rear view" on page 23
• Dual 12-48V variable DC power source input
• Up to two 300W (230V/115V) external power adapters
Notes: When one or two 300W external power adapters are installed, keep ambient temperature lower than 40°C,
and the following configuration is required:
– 8 core processor
– Four memory modules
– Up to one ThinkSystem NVIDIA A2 16GB PCIe Gen4 Passive GPU
– Up to two 7mm SATA drives
– Up to two M.2 NVMe boot drives installed on 1GbE I/O module board
– Desktop mount is supported
The models with internal power supply (AC power module board):
• Single 500W (230V/115V) AC power source input
Supported external power adapters:
As required by COMMISSION REGULATION (EU) 2019/1782 of 1 October 2019 laying down ecodesign requirements
for external power supplies pursuant to Directive 2009/125/EC of the European Parliament and of the Council and
repealing Commission Regulation (EC) No 278/2009 (ErP Lot7) for the external power supply of the product.
ThinkEdge 300W 230V/115V External Power Supply
Information published
Manufacturer's name
Model identifier
Input voltage
Input AC frequency
Output voltage
Output current
Output power
Average active efficiency
Efficiency at low load (10 %)
No-load power consumption
Minimal configuration for debugging
• One DRAM memory module in DIMM slot 1
• Depending on the model, one of the following power source:
– One 300W external power adapter
– AC power source input
– DC power source input
• One 2280 NVMe M.2 drive in Slot 1 on the I/O module board
• Two system fans
ThinkEdge SE360 V2 User Guide
8
to locate the power connector and remove the header.
Value and precision
Lenovo
ADL300SDC3A
100-240
50-60
20.0
15.0
300.0
90.00
88.07
0.15
Unit
-
-
V
Hz
V
A
W
%
%
W