Table of Contents
Advertisement
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read
"Installation Guidelines" on page 47
work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
Watch the procedure
A video of this procedure is available at YouTube:
AooAU9z6S2EXObfHoLImDm
Procedure
Note: This task requires a wrench. If necessary, use the wrench that comes in the PMB air baffle. Loosen the
screw that secures the wrench to disengage the wrench from the air baffle.
Figure 122. Disengaging the wrench
Step 1.
Insert the Bluetooth antenna into the slot.
Figure 123. Installing the Bluetooth antenna
and
"Safety inspection checklist" on page 48
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
.
Chapter 5
Hardware replacement procedures
to ensure that you
123
Advertisement
Table of Contents
Troubleshooting
