Lenovo ThinkEdge SE360 V2 User Manual page 253

b. Slide the riser card upward until the guide pins are seated in the large opening of the keyholes;
then, remove the riser card from the riser cage.
Figure 260. Removing the riser card
After this task is completed
• Install a replacement unit. See
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Demo Video
Watch the procedure on YouTube
Install components to the right wing of riser assembly
Follow instructions in this section to install components to the right wing of riser assembly.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read "Installation Guidelines" on page 47
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
"Install components to the right wing of riser assembly" on page
and "Safety inspection checklist" on page 48
54.
.
Chapter 5 Hardware replacement procedures
243.
to ensure that you
243