Table of Contents
Advertisement
Figure 340. Loosening the cables from the bracket
After this task is completed
• Install a replacement unit. See
• After completing the task with the wrench that comes in the PMB air baffle, store the wrench back to the
PMB air baffle for future use, and secure the wrench with one screw.
Figure 341. Storing the wrench
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the SMA assemblies
Follow instructions in this section to install the SMA assemblies or SMA fillers.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
"Install the SMA assemblies" on page
311.
.
Chapter 5
Hardware replacement procedures
311
Advertisement
Table of Contents
Troubleshooting
