Table of Contents
Advertisement
Step 1.
Make sure the signal cable between the front operator panel and rear operator panel is placed
outside the chassis.
Figure 157. Placing the signal cable
Step 2.
Install the internal power supply unit.
a.
Connect the PMB LED cable to the internal power supply unit.
b.
Connect the power cable from the PIB module to the internal power supply unit.
c.
Align the internal power supply unit with the busbars on the system board; then, lower the
internal power supply unit down until it is firmly seated.
Important: Make sure that the busbars are seated in the holes of internal power supply unit as
shown in the illustration. If necessary, press the blue touch points shown in the illustration.
ThinkEdge SE360 V2 User Guide
156
Advertisement
Table of Contents
Troubleshooting
