Lenovo ThinkEdge SE360 V2 User Manual page 142

• Before you remove or make changes to drives, drive controllers (including controllers that are integrated
on the system board), drive backplanes, or drive cables, make sure to back up all important data stored in
drives.
• Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration
information.
The following notes describe the type of drives that the server supports and other information that you must
consider when you install a drive. For a list of supported drives, see
• Locate the documentation that comes with the drive and follow those instructions in addition to the
instructions in this chapter.
• For a complete list of supported optional devices for the server, see
Firmware and driver download: You might need to update the firmware or driver after replacing a
component.
• Go to
https://datacentersupport.lenovo.com/products/servers/thinkedge/se360v2/7dam/downloads/driver-list/
to see the latest firmware and driver updates for your server.
• Go to "Update the firmware" on page 350
Install the bottom M.2 cabled adapter
Procedure
Step 1. Align the bottom M.2 cabled adapter with the guide pins; then, lower the adapter down until it is
firmly seated.
Step 2. Secure the bottom M.2 cabled adapter with six screws.
Figure 135. Installing the bottom M.2 cabled adapter
Step 3. Connect the cables to the bottom M.2 cabled adapter. See
cabled adapter cable routing" on page
Install an M.2 drive
If necessary, install an M.2 drive to the bottom M.2 cabled adapter.
Procedure
Step 1. Locate the slot to install the M.2 drive.
Note: Slot 11 and Slot 12 on the bottom M.2 cabled adapter are available to install M.2 drives. Do
not install M.2 drives to other slots.
ThinkEdge SE360 V2 User Guide
132
https://serverproven.lenovo.com
for more information on firmware updating tools.
342.
https://serverproven.lenovo.com
"Riser assembly and bottom M.2
.
.